| Electronic Indicator Control |  View Product | Electronic Indicator ControlDescription: Three features combined into one sophisticated control — the popular Bennett rocker switch control, trim tab indicator and the Auto Tab Retractor. Water resistant, highly accurate and features variable intensity LEDs for night or day. Features a relay module mounted near the transom, which simplifies installation by reducing the number of wires to run to the helm.
Standard kit is 12V and includes:
• EIC Display (EIC001)
• 12V EIC Relay Module (EIC101)
• Sensor with 10' SC Red and Connector (EIC901P)
• Sensor with 10' SC Green and Connector (EIC901S)
• 20' EIC Cable (EIC201)
• EIC Pigtail Pack (EIC401)
• EIC Hardware Pack (EIC501)
24 volt kit also available - Part# EIC50002.
Click here for a complete list of EIC kits and replacement parts.
View More Information |
|
| NMEA 2000 Indicator Kit |  View Product | NMEA 2000 Indicator KitDescription: See the position of your trim tabs on your NMEA 2000 compatible multi-function display or gauge, GPS/chartplotter or sonar. (Display not included in kit.) One-year warranty.
Compatible with NMEA 2000® compliant electronics. IMPORTANT: Contact your electronics manufacturer first to verify compatibility. To determine compatibility, ask if the manufacturer has 1) Implemented the trim tab portion of the NMEA standard (ability to view the tabs), and 2) Enabled the ability to configure calibration (see movement of the tabs).
The kit comes with (see numbered items in photo -
click here for enlarged photo):
1) White plastic clip - used to snap on actuator piston shaft when installing new upper hinges with sensors
2) Red butt connectors – used to connect sensors with the NMEA1 Module
3) NMEA1 Module – connects Bennett trim tab sensors to NMEA-compatible electronics
4) Two sensor rods – measure trim tab position
5) Upper Hinges with coil (1 with red sensor wire and 1 with green sensor wire) – measure trim tab position View More Information |
|
| Tab Position Indicator |  View Product | Tab Position IndicatorDescription: Attractive, compact, water resistant and easy to install. The TPI helm display accurately shows deflection percentage of each trim tab, and the LED brightness is adjustable for any lighting condition. Works with all Bennett Trim Tabs.
Standard kit for single station includes:
• TPI Helm Display (TPIDISPLAY)
• TPI Hardware Kit (TPIH1170ATPI)
• Actuator Upper Hinge with Coil – Port (red) 30ft. (CC3003P)
• Actuator Upper Hinge with Coil – Starboard (green) 30ft. (CC3003S)
View More Information |
|
|
